15
Caliper Piston Installation
Hold the banjo at the desired angle.
Use a torque wrench with a T25 TORX bit socket to tighten the bolt to
4.4-5.4 N
·
m (39-48 in-lb).
Insert the Guide bleed block into the caliper.
Use a 2.5 mm hex wrench to install the pad retention bolt
⚠
WARNING
You must bleed your brakes before reinstalling the brake pads.
Installing the brake pads prior to bleeding the brakes could
contaminate the brake pads and lead to a brake failure.
Spray isopropyl alcohol on the caliper and clean it with a rag.
Visually check your work. If any of the o-rings protrude from the banjo fitting or banjo bolt, remove and replace the o-rings, then repeat the installation
process.
⚠
CAUTION
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed and brake hose shortening instructions, visit
.
7
T25 TORX bit
4.4-5.4 N
·
m (39-48 in-lb)
22 mm
7
8
Bleed block
15 N•m (133 in-lb)
22 mm
9
