45
Bleed Procedure
Fully extend the rebound damper shaft. Push the syringe handle
Fully extend the rebound damper shaft. Push the syringe handle
down, then release the plunger. Allow the bladder to come to a natural
down, then release the plunger. Allow the bladder to come to a natural
resting position by waiting a few moments until the syringe stops
resting position by waiting a few moments until the syringe stops
filling.
filling.
Use a shop towel to cover the bleed tip and charger bleed port, then
Use a shop towel to cover the bleed tip and charger bleed port, then
unthread and remove the syringe.
unthread and remove the syringe.
⚠
CAUTION - EYE HAZARD
Oil may eject from the bladder assembly if the bladder is not in its
resting position. Wear safety glasses.
Install the bleed screw.
Install the bleed screw.
Cycle the rebound damper shaft a few times.
Cycle the rebound damper shaft a few times.
Remove the bottom bolt from rebound damper shaft.
Remove the bottom bolt from rebound damper shaft.
Clean the Charger 2 Damper assembly.
Clean the Charger 2 Damper assembly.
9
10
T10
1.7 N·m (15 in-lb)
T10
1.7 N·m (15 in-lb)
11