27
Charger Damper Removal
Use your fingers or a pick to remove the compression top cap o-ring.
Use your fingers to install a new o-ring.
Lightly clamp the cartridge tube into a bicycle stand with the rebound
damper shaft oriented upward.
NOTICE
Clamp the cartridge tube into the bicycle just tighten enough so that it
does not slip or spin. The tube can deform if clamped too tightly.
Place a 21 mm open end wrench on the wrench flats of the cartridge
tube. Place a 23 mm open end wrench on the damper seal head.
Holding the cartridge tube in place, turn the damper seal head
counter-clockwise to loosen and remove the rebound assembly.
Remove the cartridge tube from the bicycle stand and pour the
suspension oil into an oil pan.
Remove the seal head assembly from the rebound damper shaft.
Discard the damper seal head assembly.
4
5
21 mm
23 mm
6
7
