Waukesha Cherry-Burrell
Maintenance
11/2012
95-03057
Page 49
10. Make sure O-ring (See Figure 35, Item A) is installed in the
opposite drive end head. Lubricate lightly
11. Install opposite drive end head by reversing procedure for
removal of head.
12. Install shaft bearing in head. Install HRT into the end of the
shaft and slide head and bearing onto the shaft. Remove
HRT.
13. Push on bearing retainer and secure with clamp.
14. Install shaft nut onto shaft
(nut is left hand threaded)
and
tighten nut against bearing’s inner race
.
15. Lift the shaft and head, place over the tube ring and position
bayonet closure. Close locking latch and secure by tightening
latch retainer nut.
16. Install all product connections and seal flush piping.
17. Inspect unit for correct assembly.
18. Remove tag-out and lock-out. Prepare unit for operation.
Figure 35 - Opposite Drive End Head
O-ring
Figure 36 - Install Head Shaft Bearing
Figure 37 - Installation of Shaft
Locknut
Figure 38 - Installation of Hinged
Clamp
