10
AIR CONDITIONER FEATURES
TO SELECT THE OPERATING MODE:
To choose operating mode, press Mode button. With
each press of the button, the mode will cycle through the
following sequence: Auto, Cool, Dry and Fan. The
indicator light next to each corresponding model will
illuminate.
Note: unit will automatically initiate the Energy Saver
function under Cool, Dry and Auto modes.
AUTO mode:
When the air conditioner is set in AUTO mode,
unit will automatically select cooling or fan
operation, based on set and ambient
temperature.
Unit engages COOL mode when ambient
temperature is 4°F above set temperature. When
ambient temperature falls 2°F below set
temperature, unit will switch to Fan.
Fan speed cannot be adjusted in AUTO mode.
COOL mode:
Unit begins cooling when ambient temperature is 2°F
above set temperature. When set temperature has
been reached, cooling stops and unit switches to Fan.
DRY mode:
In this mode, unit will generally operate in the form of
a dehumidifier. Since the conditioned space is closed
or seals area, some degree of cooling will occur.
FAN mode:
Use this function when cooling is not desired,
such as for air circulation or to exhaust stale air.
Best to open windows when operating in Fan
mode but remember to close windows in Cool
mode for maximum cooling efficiency.
Fan speed can be adjusted.
Display will show ambient room temperature.
Temperature cannot be set or adjusted.
SLEEP FEATURE:
Press Sleep button to initiate the sleep mode.
The unit will operate at the set temperature for 30
minutes and proceed to increase temperature by 2
°F.
After another 30 minutes, unit will again increase
temperature by 2°F. This new temperature will be
maintained for 6 hours then return
to the originally set
temperature. This ends the Sleep mode and unit
will continue to operate as originally programmed.
Sleep mode can be cancelled at anytime during
operation by pressing the Sleep button again.
ENERGY SAVER FEATURE:
Press
Energy saver button to initiate this function.
This function is available for COOL, DRY and AUTO
modes.When the set temperature has been reached
and compressor shuts off, fan will continue to run for
another 3 minutes, then cycles on for 2 minutes at
10-minute intervals until the room temperature is above
the set temperature, at which point the compressor turns
back on and cooling resumes.
FOLLOW ME FEATURE:
Light flashing
Follow
Me
Energy
Saver
On/Off
This feature can be ONLY be activated from
the remote control. The remote control
's
thermostat
serves as the temperature control
point.
To activate the Follow Me feature, point the remote
control towards the unit and press the Follow Me
button. The remote will display ambient temperature
of its current location. The remote control will send
signal to the air conditioner every 3 minutes until
Follow Me feature is turned off. If the unit does not
receive the Follow Me signal for 7 minutes, unit will
beep and end the Follow Me feature.
TIMER: AUTO START/STOP FEATURE:
Press the TIMER button to program Auto-On or
Auto-Off. The corresponding indicator light will
illuminate.
Use the Left/Right arrow buttons to program. each
press is in increment of 0.5 hours up to 10 hours,
then in increments of 1 hour up to 24 hours. the
control will count down the remaining time.
Unit will register timer setting after 5 seconds. If
unit is on, display will revert back to previous
temperature setting or room temperature. If unit is
off, there will be no display.
Turning the unit on or off or adjusting the timer to
0.0 will cancel the timer program.
TO ADJUST FAN SPEEDS:
Press to select the Fan Speed in four steps-Auto,
Low, Med or High. Each time the button is pressed,
the fan speed mode is shifted. On Dry mode,the fan
speed is controlled at Low automatically.
If the unit breaks off unexpectedly due to the power
cut, it will restart at the previous function/setting
automatically when the power resumes.
AUTO RESTART FEATURE:
