80
This document is written and published by ShockWatch, Inc. All rights reserved.
USER MANUAL
desired setup file. Please note that if passwords are required, they must have been setup within the setup file
before sending to the iButton. Refer to the File Setup section earlier in this manual.
SETUP PASSWORDS
ShockLog passwords allow users to protect their units from unauthorized access, download and corruption. The
ShockLog passwords are factory defined for every ShockLog and are unique to each ShockLog serial number.
To set the passwords within a ShockLog, activate the “Setup Passwords” key on the Communications window. Go
to the View menu and select the “Password Setup” button. The “Password Setup” button will now be available in
the Communications window.
Attach the ShockLog to the PC, click on the “Password Setup” button in the Communications window and a new
window will open. Enter the 8 digit numeric code (provided with the ShockLog), click “Enable Passwords” and
then “OK.”
The Status bar will show that the system is connecting to the ShockLog and will return “OK.” The ShockLog is now
password protected.
Now, when a user attempts to communicate with the ShockLog, it will be necessary to enter an appropriate level
password to gain access. A window requesting the required level of password will be displayed. The following
levels are required:
Stop
Level 1
Start
Level 1
Download
Level 2
Send Setup
Level 2
Set Clock
Level 1
Read Setup
Level 2
Note: The ShockLog program has been set up to memorize a password while in the same session with the same ShockLog
attached. Once a password has been entered, it will not need to be re-entered until a new ShockLog session is opened.
To remove the password from a ShockLog unit, attach the ShockLog to the PC and open the Communication
window. Click on the Setup Password button and enter the Level 2 password but this time select “OK” when the
“Enable Passwords” button has not been selected. The password settings will be removed from the ShockLog.
Summary of Contents for ShockLog 248
Page 1: ...USER MANUAL...