Periodically monitor the position of the belt to ensure peak performance:
Over tightening of the belt causes damage and premature failure of the
precision bearings in the front and rear rollers.
When you are using the treadmill, if you feel a pause in the belt with each foot plant,
the belt is too loose. Stop the machine to check the belt tension, pull the running
belt up in the middle (see Fig. 12-1 & 12-2). There should be about 30 m/m (1 1/8")
or 3 kgs of "give" in the belt (see Fig. 12-3). If there is too much, adjust both rear
roller bolts clockwise 1/2 turn at a time (see Fig. 12-1). Then, check the belt tension
again, if more adjusting is required, give both adjusting bolts another slight turn. Do
not adjust over 2 full turns.
Conversely, if there is not enough "give", adjust both rear roller bolts
counterclockwise 1/2 turn at a time.
To avoid injury, special care must be taken when adjusting the running
belt. Remove any loose clothing or shoelaces and tie back your hair. Be
very careful to keep your fingers or any other objects clear of the belt
and rollers.
The treadmill is designed to carry specific weights at specific speeds. The treadmill
will not stop immediately if an object becomes caught in the belt or rollers.
CAUTION:
Fig.12-1
Fig.12-2
Fig.12-3
PDF created with FinePrint pdfFactory Pro trial version
