6
6. PROGRAMMING YOUR FINGERPRINT
2. PLACE AND HOLD the pad of
your thumb on the scanner until
indicator ring and LED light flash
green once and beeps once.
3. REPEAT at least 3 more times until
there are 2 consecutive beeps and
2 green flashes.
LIFT FINGER
St
ep 2
St
ep 3
2 GREEN F 2 BEEPS = SUCCESS!
St
ep 1
NOTE:
Programming mode will time
out after 10 seconds of
inactivity. If this occurs press
reset button and begin again.
1.
On the inside of the safe, near
the battery compartment, locate
the brass cap. Unscrew and
remove the cap. Press and release
the reset button. The indicator
ring will illuminate indicating the
safe is now in programming mode.
*Keep safe door open while
programming new fingerprint*
x
1
x
1
GREEN
LIGHT
x
2
x
2
GREEN
LIGHT
Red Reset Button
Brass Cap
BEEP
BEEP
BEEP
HOLD FOR BEEP
