74
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
1) The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware.
2) The crank arm nut and/or the pedals need to be retightened.
3. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling
pads on the bottom of the rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust
the levelers.
WARNING
The effect that the safety level of the equipment can be maintained only if it is examined
regularly for damage and wear.
1) Replace defective components immediately and/or keep the equipment out of use
until repair.
2) The components which are most susceptible to wear: Belt
、
PU wheel
、
Bearing
、
Idler
、
Shaft
、
Pedal
Summary of Contents for CR 900 TFT
Page 33: ...33 EXPLOSIONSZEICHNUNG ...
Page 75: ...75 EXPLODED VIEW DIAGRAM ...
