CUSTOMER SERVICE 1-888-707-1880
Dyaco Canada Inc.©2013
8
STEP 2:
Connecting & Lower Swing Arms
1. Slide two Wave Washers
(150)
onto each side of the Swing Arm Axle. Slide the Lower Swing
Arms (
10
Left,
11
Right) onto the axles and secure with the two Hex Head Bolts
(99)
and Flat
Washers
(141)
. Do not force the Swing Arms onto the axle. They should slide on, but you
may need to jiggle them to get them lined up properly. The Swing Arms have been previously
installed at the factor y so they do fit properly.
2. Remove the tie that holds the spacer in the rod end located at the end of the Right
Connecting Arm
(9)
and line up the rod end with the bracket at the bottom of the Lower Right
Swing Arm
(11)
. Slide the Hex Head Bolt
(101)
through the bracket of the Lower Swing Arm
and then through the rod end and spacer. Install the Flat Washer
(142)
and Nyloc Nut
(127)
on the bolt and tighten as much as possible. Repeat this step for the left side. Tighten using
the Wrenches (
155
&
158
).
HARDWARE
#101.
5/16" × 1- 1/4"
Hex Head Bolt (2 pcs)
#150.
Ø
17 m/m
Wavy Washer (4 pcs)
#141.
5/16" × 23 × 1.5T
Flat Washer (2 pcs)
#192.
5/16" × 9T
Nyloc Nut (2 pcs)
#142.
5/16" × 20 × 1.5T
Flat Washer (2 pcs)
#99.
5/16" × 15mm
Hex Head Bolt (2 pcs)
