IM-P180-31
CMGT Issue 11
5
1.13 Residual hazards
In normal use the external surface of the product may be very hot. If used at the maximum permitted
operating conditions the surface temperature of some products may reach temperatures in excess
of 177 °C (350 °F).
Take due care when dismantling or removing the product from an installation (refer to Section 6
'Maintenance instructions').
1.14 Freezing
Provision must be made to protect systems which are not self-draining against frost damage in
environments where they may be exposed to temperatures below freezing point.
1.15 Disposal
Unless otherwise stated in the Installation and Maintenance Instructions, this product is recyclable
and no ecological hazard is anticipated with its disposal providing due care is taken.
Viton:
-
Can be landfilled, when in compliance with National and Local regulations.
-
Can be incinerated, but a scrubber must be used to remove Hydrogen Flouride, which is evolved
from the product and with compliance to National and Local regulations.
-
Is insoluble in aquatic media.
PTFE:
-
Can only be disposed of by approved methods, not incineration.
-
Keep PTFE waste in a separate container do not mix it with other rubbish, and consign it to a
landfill site.
1.16 Returning products
Customers and stockists are reminded that under EC Health, Safety and Environment Law, when
returning products to Spirax Sarco they must provide information on any hazards and the precautions
to be taken due to contamination residues or mechanical damage which may present a health,
safety or environmental risk. This information must be provided in writing including Health and
Safety data sheets relating to any substances identified as hazardous or potentially hazardous.
Summary of Contents for BT6-B
Page 2: ...IM P180 31 CMGT Issue 11 2...