SpinCore Technologies PB12-100-4k, Owner'S Manual

Page: 21 / 39

PulseBlaster
Pin Assignments
Pin# Pin#
1 Bit 12 13 Bit 18
2 GND 14 GND
3 Bit 13 15 Bit 19
4 GND 16 GND
5 Bit 14 17 Bit 20
6 GND 18 GND
7 Bit 15 19 Bit 21
8 GND 20 GND
9 Bit 16 21 Bit 22
10 GND 22 GND
11 Bit 17 23 Bit 23
12 GND 24 GND
Table 3: Higher 12 output bits and 12 ground lines on the 24 pin IDC connector.
Shrouded IDC Connector Flag24..26 - Pin Assignments
The shrouded IDC connector labeled Flag 24..26 outputs three status signals: Reset, Running,
and Waiting. Please consult the table below for pin assignments.
Pin Assignments
Pin# Pin#
1 Reset 13 GND
2 GND 14 GND
3 Running 15 GND
4 GND 16 GND
5 Waiting 17 GND
6 GND 18 GND
7 GND 19 GND
8 GND 20 GND
9 GND 21 GND
10 GND 22 GND
11 GND 23 GND
12 GND 24 GND
Table 4: 3 status signals and 21 ground lines on the 24 pin IDC connector.
The status pins correspond to the current state of the pulse program and are defined as follows:
Reset – Driven high when the PulseBlaster device is in a RESET state and must be
reprogrammed before code execution can begin again.
Running – Driven high when the PulseBlaster device is executing a program. It is low when the
PulseBlaster enters either a reset or idle state.
http://www.spincore.com 2021/03/22 21