PulseBlaster
Figure 4 below shows a typical pattern displayed by an oscilloscope when running pb24_ex1.exe with
the above described connections. Verifying this behavior confirms the board is installed properly.
2021/03/22
10
Figure 2:
Left: BNC T-Adapter and Right: BNC 50 Ohm resistor.
Figure 4:
Expected signal from a PulseBlaster output running pb24_ex1.exe.
Figure 3:
BNC T-Adapter on the oscilloscope input channel with coaxial transmission line
connected on the left and BNC 50 Ohm resistor connected to the right to terminate the line.
