Spectrum Digital TMS320DM365, Technical Reference

Page: 52 / 140

Spectrum Digital, Inc
3-8 DM365 EVM Technical Reference
3.2.3 J3, MSP430 JTAG Header
The J3, MSP430 JTAG header, is located on the top side of the board and is used to
provide a programming interface to the MSP430 microcontroller. The pinout for
the J3 connector is shown in the table below. This connector is typically used for
factory use only.
3.2.4 J4, Spare Jumper Holder
J4 is a 3 x 2 connector used to hold unused jumper plugs that from time to time may
be required in other connectors/jumpers on the D365 EVM. The pins on this connector
are not connected to any signals.
Table 4: J3, MSP430 JTAG Header
Pin # Signal Pin # Signal
1 430_TDO/TDI 2 NC
3 NC 4 MSP430_3V3
5 NC 6 NC
7 TCK 8 NC
9 GND 10 NC
11 NC 12 NC
13 NC 14 NC
2
MSP430 EMU
1
Figure 3-4, J3, MSP430 JTAG Header