Spectrum Controls Micro800 2085sc-IF16C, User Manual, Page: 44 / 60

3-18 Chapter 3: Configuring the 2085sc-IF16 Using CCW
User’s Manual Pub. 0300306-02 Rev. B
Bit Name Description
Bit 0/
Bit 8
Channel Fault
0: No Channel Fault
1: Channel Fault
This bit is set when the channel has an open circuit condition,
data error, or under/over range condition. It is also set if the
Module Power Up bit is set or the Module General Fault bit is
set.
Bit 1/
Bit 9
Data Error
0: No Data Error
1: Data Error
This bit is set for an enabled channel that is not receiving a
reading from the ADC. When set, the respective channel data
value remains the same as the previous sample.
Bit 2/
Bit 10
Process Alarm Low
0: No Alarm
1: Alarm
Bit 3/
Bit 11
Process Alarm High
0: No Alarm
1: Alarm
Bit 4/
Bit 12
Under-range
0: Not Under-range
1: Input Signal Under-range
Bit 5/
Bit 13
Over-range
0: Not Over-range
1: Input Signal Over-range
Bit 6/
Bit 14
Open Circuit
0: No Open Circuit
1: Open Circuit Condition Detected
Bit 7/
Bit 15
(unused) (unused)
3.5.11 Module Status Struct Bit Definitions
The structure definition for the 'Module Status' word in the Input Assembly table
is described below. These struct is provided for convenient monitoring for any
module errors. Unused bits are 0.
Bit Name Description
Bit 0-12 (unused) (unused)
Bit 13 Invalid Serial Number
Data
0: Serial Number Valid
1: Serial Number Invalid
This bit is set if the factory-programmed serial number data is
missing or has become corrupt.
Bit 14 Invalid Calibration Data 0: Calibration Valid
1: Calibration Invalid
This bit is set if the module's calibration data has not been
programmed or has become corrupt.