Spectrum Controls Micro800 2085sc-IF16C, User Manual, Page: 25 / 60

Chapter 2: Installation and Wiring 2-7
User’s Manual Pub. 0300306-02 Rev. B
1. Place the module next to the controller against the panel where you are
mounting the module.
2. Mark drilling holes through the mounting screw holes and mounting feet,
and then remove the module.
3. Drill the holes at the markings.
4. Replace the module and mount it. Leave the protective debris strip in
place until you are finished wiring the module, and any other devices.
2.4.2 Wiring Diagram
WARNING
Hazard of damage to the terminal connector.
The Spectrum Controls RTB hold down and terminal screws must be
tightened by hand using the guidelines. They must not be tightened using a
power tool. Use a screwdriver of 0.8 × 2 mm and tighten to no more than
0.25 N-m (2.2 lb-in) torque.
Failure to follow these guidelines may result in damage to your connector.
The following images explain the general layout of the module terminal blocks
and the associated wiring diagrams for the various input signals and the 2085sc-
IF16C or 2085sc-IF16V module:
RTB1# Name
1 IN0+
2 IN0-
3 IN1+
4 IN1-
5 IN2+
6 IN2-
7 IN3+
8 IN3-
9 IN4+
10 IN4-
11 IN5+
12 IN5-
13 IN6+
14 IN6-
15 IN7+
16 IN7-
17 NC
18 NC
RTB2# Name
19 IN8+
20 IN8-
21 IN9+
22 IN9-
23 IN10+
24 IN10-
25 IN11+
26 IN11-
27 IN12+
28 IN12-
29 IN13+
30 IN13-
31 IN14+
32 IN14-
33 IN15+
34 IN15-
35 NC
36 NC