Spectrum Controls 1746sc-INI4i, User Manual

Page: 16 / 56

2-2 Chapter 2: Installation and Wiring
User’s Manual Pub. 0300128-04 Rev. A
Industrial and Commercial Power Systems.
• Noise Reduction Techniques in Electronic Systems , by Henry W. Ott;
published by Wiley-Interscience of New York in 1976.
Section 2.1
Prevent
Electrostatic
Discharge
WARNING
Electrostatic discharge can damage integrated circuits or semiconductors if
you touch analog module card bus connector pins or the terminal block on
the module. Follow these guidelines when you handle the module:
• Touch a grounded object to discharge static potential.
•
Wear an approved wrist-strap grounding device.
•
Do not touch the bus connector or connector pins.
•
Do not touch circuit components inside the module.
• If available, use a static-safe workstation.
• When it is not in use, keep the module in its static-shield bag.
Section 2.2
Compliance
to European Directive
If this product bears the CE marking, it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet the
following directives.
Section 2.3
EMC Directive
This product is tested to meet Council Directive 2014/30/EU Electromagnetic
Compatibility (EMC) and the following standards, in whole or in part,
documented in a technical construction file:
•
EN 61000-6-4 Electromagnetic compatibility (EMC)–Part 6-4: Generic
standards–Emission standard for industrial environments.
•
EN 61000-6-2 Electromagnetic compatibility (EMC)–Part 6-2: Generic
standards–Immunity for industrial environments.
UKCA Electromagnetic Compatibility Regulations 2016
•
BS EN 61131-2, BS EN 61000-6-4, BS EN 61000-6-2.
This product is intended for use in an industrial environment.
Section 2.4
Low Voltage Directive
This product is tested to meet Council Directive 2014/35/EU Low Voltage, by
applying the safety requirements of EN 61010-2-201 Safety Requirements for
Electrical Equipment for Measurement, Control, and Laboratory Use - Part 2-