Chapter 2: Installation and Wiring
2-5
User’s Manual Pub. 0300266-04 Rev. A
To remove the terminal block, unscrew the two retaining screws at the top and
bottom of the terminal block, and using a screwdriver or needle-nose pliers,
carefully pry the terminal block loose.
To insert your module into the rack, follow these steps:
1.
Align the circuit board of your module with the card guides at the top
and bottom of the chassis.
2.
Slide your module into the chassis until both top and bottom retaining
clips are secure. Apply firm even pressure on your module to attach it to
its backplane connector. Never force your module into the slot.
3.
Cover all unused slots with the Card Slot Filler, Allen-Bradley part
number 1746-N2.
4.
To remove your module, press the retaining clips at the top and bottom
of your module and slide it out.
Section 2.8
Wiring Your
Module
To wire the terminal block, you need:
•
A small, flat-blade screwdriver.
•
Belden 8761 (shielded, twisted pair) cable or equivalent.
Summary of Contents for 1746sc-INI4i
