SpectraLink DECT Server 8000, Installation Manual

Page: 13 / 42

Spectralink DECT Server 8000 Installation Guide
14184630 Version 8.0, K016
September, 2015
11
Installing the DECT Server 8000 on a Flat Surface
Before you start installation take notice of the following safety precautions.
Flat Surface Mounting Safety Precautions
•
Ensure the surface can support the weight of the unit.
•
Never install the Spectralink DECT Server 8000 on the floor.
•
Never place anything, except ONE additional Spectralink DECT Server 8000 unit, on top of
the Spectralink DECT Server 8000. The top plate must be free to allow sufficient cooling.
To Install the DECT Server 8000 on a Flat Surface
1
Remove the Spectralink DECT Server 8000 from its package.
2
Before placing the unit, carefully turn it upside down and mount the four rubber pads supplied
in the package. One must be placed at each corner of the bottom plate.
3
Place it on a clean, flat, horizontal surface.
Installing the Spectralink DECT Server 8000 on a Wall
Before you start installation take notice of the following safety precautions.
Wall Mounting Safety Precautions
•
Ensure the wall quality is good enough for holding the unit. Avoid high-porous surfaces, joints
and similar.
•
Never use countersunk screws.
•
Leave at least 10 centimeter of free air above the unit for ventilation.
To Install the Spectralink DECT Server 8000 Using the Wall Hanger
For free hanging installations, you use the wall hanger.
1
Find a suitable spot on an even closed-textured surface. The unit should be placed minimum
1 meter above ground surface and minimum 20 centimeter from any corner.