Speck pumpen BADU Jet Primavera, Original Operation Manual

Page: 69 / 260

5 Installation
12/2014 VG 766.2320.050 EN 69
9. Align the stainless-steel cover with the protruding centring nubs to
the existing recesses of the suction panel
(93) and press them
together by hand. Observe the "UP" marking on the stainless-steel
cover. To fasten the cover use a screwdriver to bend the two
offset tabs towards the back
(Fig. 11) .
10. Lead the pneumatic hoses through the lower/outer openings of the
light cover (110) (light ON/OFF left; pump ON/OFF right). Align the
light cover (110) central to the nozzle housing (102.1) and fasten
with four tapping screws (112) (Fig. 12) .
Only tighten the screws hand-tight. Do not use any force!
11. Slide one O-ring (37) onto each pneumatic button (38/1; 38/2) .
Fasten the pneumatic hoses to the corresponding buttons using
the hose clamps
(46) . Insert the two pneumatic buttons through
the light cover (110) in the nozzle housing and lock by turning it
clockwise (Fig. 12) .
12. Mount the cap for the volume (21/1) and air regulator (111) by
means of a rubber mallet and a protective cloth (Fig. 13) .
13. Connect or bond the jet pump (92) with the suction tube (105.1) ,
adapter (97) and screwed connection (98; 99) and at the intake
side with the pressure tube (106.1) and special reducer (79) at the
delivery side (Fig. 14) .
14. Connect the pump motor in accordance with the wiring diagram.
Ensure that the direction of rotation is correct for three-phase
current! Only carry out the direction of rotation check when
the pump is completely filled with water!
15. Switching on and off from the pool using the pneumatic buttons:

Pump ON/OFF (38/1) - right-hand button

Light ON/OFF (38/2) - left-hand button
Volume regulator from the pool with the rotary button (21/1) :

OPEN - Left rotation

CLOSE - Right rotation
Air can optionally be added with the air regulator (111) from the
pool:

OPEN - Left rotation

CLOSE - Right rotation