Spearhead Star-Cut
910/1210
Machine Protection
To prevent gearbox damage all rotors are protected by slip clutches fitted to each of
the drive shafts. When cutting in extreme conditions where stumps, rocks and other
such solid objects are likely to be found it is recommended that the operator reduces
the engine revs to allow the blades to pivot more easily when striking solid objects
and proceed with caution.
The clutch settings should not be altered without reference to Service and
Maintenance. Never over-tighten the pressure springs on the slip clutches (Fig. 8) as
this could result in severe damage to the gearbox and drive lines, as well as
invalidating the warranty.
If the machine has been laid up for any length of time, there is a risk of the
clutch plates rusting and seizing together. Never operate the machine in this
condition
, as there will be no protection to the driveline and gearboxes against
shock loading. To free the clutch plates first slacken all pressure spring bolts and run
up the machine for a short period, deliberately try to cause the clutch to slip. Finally
re-tighten the tension spring bolts to their original length, taking great care not to
over-tighten.
If in any doubt, consult Spearhead’s Service Department or your local Spearhead
Dealer for further advice.
Fig. 8
Slip Clutch
Warning
Never carry out any servicing or maintenance work without
first disengaging the PTO and then stopping the tractor
engine before leaving the seat.
On delivery of your machine check that the dealer has
completed the P.D.I Form, ensure the Warranty Registration
Form is completed and returned.
21