38
FAILURE
REASON
SOLUTION
Hydraulic reel does not wind the hose.
Handle in wrong position .
Put the handle into the correct position .
Hydraulic tank almost empty .
Refill the tank . Check the system for
leakage .
Attachment bolt for control lever of
hydraulic system is loose .
Fasten the bolt and put the lever into the
correct position .
Working pressure set too low .
Increase the working pressure, if possible .
Hydraulic tank return filter dirty .
Switch off the machine and clean the
return filter .
Hydraulic system damaged .
Contact Spartan Tool Customer Service .
No reaction from the Riomote controller.
No current .
Recharge the battery .
Use new battery .
Contact points are dirty .
Check fuses .
Contact Spartan Tool Customer Service if
problem is frequent or ongoing .
Transmitter is not on .
Activate the transmitter (link to the
receiver) .
Transmitter out of reach from receiver .
Put the machines closer together . Move
transmitter closer .
Warning signal after short working time.
Battery discharged / defective .
Charge or replace the Riomote® battery .
Check the terminal connections .
Transmitter indications are good but
functions are not executed.
Emergency stop pushed in .
Unlock emergency stop .
Receiver has no current .
Check / replace fuses .
No radio connection .
Check functions of control lights .
Certain functions are not executed.
Receiver is faulty .
Contact Spartan Tool Customer Service .
Interruption in electric current .
Check all plugs . Plug in and push . Check
control lights if functions are indicated .
Troubleshooting
