SR85 REMOTE CONTROL CAR ALARM SYSTEM
8
ARMED INDICATOR LED
Remove the retaining nut from the LED bezel.
Drill a suitable
mounting hole in the dashboard where the indicator may be seen
from the exterior of the vehicle as a visible deterrent. Feed the two
way connector and wire through the hole and secure the LED with
the retaining nut (see Fig.3). Route the wire through a bulkhead
grommet to the alarm and push it carefully through the flexible
rubber boot. Insert the two way connector from the LED into the
socket on the rear of the alarm unit.
PURPLE AND GREY WIRES-INDICATORS
PURPLE (R/H): Using the vehicles wiring diagram or with the aid of
a 12 volt test lamp, locate the wire at the indicator switch which
illuminates the test lamp when the RIGHT indicator flashes.
Connect the PURPLE wire to this wire using solder joint, crimp
termination’s or an IDC connector. GREY (L/H): Repeat the above
procedure connecting the GREY wire to the LEFT hand indicator
circuit.
NOTE:
The alarm gives a 12 volt (+) positive output to flash the
indicators. In the rare case the indicators are negatively
(earth) switched, contact Sparkrite for assistance.
GREEN WIRE-ALARM ANTENNA
The GREEN antenna wire must not be cut or connected to anything
metal otherwise the alarm operating range will be affected. Extend
the GREEN wire and secure to the outside of the wiring harness to
achieve optimum performance. Ensure the wire cannot come into
contact with a hot surface, bare metal or immersed in water.
