SR85 REMOTE CONTROL CAR ALARM SYSTEM
10
BLUE WIRE-DOOR SWITCH
NOTE:
To ensure correct operation of your alarm, the BLUE wire
must be connected prior to connecting the BLACK earth
wire or the RED main alarm supply wire.
Most four door cars operate the courtesy light from all four doors so
connecting the alarm to one door switch will connect all of the doors.
The BLUE alarm wire should be connected to the existing door
switches provided they are of the switched earth type. To determine
this, close all doors except the drivers door.
The courtesy light
should be on. Remove the retaining screw from the door switch and
carefully pull out the switch. If the interior light goes out when the
door switch is removed your existing courtesy light switches are
suitable for direct connection to the BLUE ALARM wire.
The BLUE wire can then be connected to the door switch wire using
solder joint, crimp termination or an IDC connector.
If the courtesy light remains on when the door switch is removed,
contact Sparkrite for installation details specific to your car.
BLACK WIRE-EARTH
The BLACK wire must be connected to a good clean metal earthing
point on the body work of the vehicle. Drill a suitable hole near the
main alarm unit and secure the BLACK wire through the ring
terminal.
NOTE:
Do not mount the BLACK earth wire on the alarm bracket
as the anti-corrosion paint will prevent a good earth
contact.
If in any doubt the BLACK earth wire can be
connected direct to the battery negative terminal.
