If you soldered in an LED backwards by mistake, have no fear. Visit the
Troubleshooting LEDs section to find out how to easily correct it.
Congratulations! You have completed the soldering portion of assembly.
You’re almost done!
Cleaning
Before we move on to the final assembly steps, this is a good time to clean
your board. Note, this is not absolutely necessary; your Simon Tilts will
most likely work even without cleaning. We suggest cleaning it to avoid
getting flux on your fingers during game play.
To clean your Simon Tilts, first ensure that you do not have the batteries
installed.
You can clean your board using an old toothbrush and some DI water or
alcohol.
If you have compressed air, this is a quick way to blow off any liquid. If not,
then a paper towel or tissue paper can do the trick.
If you’d like to learn more about cleaning, please check out this tutorial:
Electronics Assembly - Washing
Tilt Arms
The last step is assembling and mounting your three tilt arms.
First, find the three red tilt arms:
Next, “pop” a BB into each one:
Page 13 of 20
