SV Series
Spa Controls
7
SV4.T Keypad Overview
Buttons and indicator LEDs
SANITISER INDICATOR LED
This LED will turn on to indicate
that the ozone or uv sanitiser unit
is operating (if fitted).
LIGHT (SPEED / COLOUR) BUTTON
Press to activate light speed or user colour
selection menus. Use up & down buttons to
adjust.
OK BUTTON
Used to confirm and save setting adjustments
or to enter setting adjustment menus.
INVERT SCREEN BUTTON
Press to flip screen 180
o
for easy viewing
when spa in use.
DOWN BUTTON
Short single presses toggle through the three display
modes: W.TMP = Water Temperature, S.TMP = Set
Temperature, TIME = Clock.
Holding the button will force the controller to begin
adjusting the set temperature and will lower the set
temperature point.
Also used for adjusting settings.
SANITISE BUTTON
Press once to
activate a 20 minute
sanitisation and
clean up cycle to
refresh water quality
after spa use. A
second press will
cancel the cycle if
already running.
BLOWER BUTTON
Press to toggle blower
on/off. A single press
turns blower on in
vari-speed mode. Use
up & down buttons to
vary speed. A double
press activates the
ramping mode.
PUMP (A,B,C,D)
BUTTONS
Used to toggle the filtration pump and / or
any additional jet pump(s) on / off (if fitted).
SLEEP TIMER
INDICATOR LED
This LED will turn on
when the controller is
in a sleep mode.
HEATER INDICATOR LED
This LED will turn on when the
heater or heat pump (if fitted)
is operating.
AUTOMATIC INDICATOR LED
This LED will turn on whenever the
filtration pump is in automatic mode.
LIGHT (ON / OFF) BUTTON
Press to toggle spa lights on / off.
A B C D
UP BUTTON
Short single presses toggle through the three
display modes: W.TMP = Water Temperature,
S.TMP = Set Temperature, TIME = Clock.
Holding the button will force the controller to
begin adjusting the set temperature and will raise
the set temperature point.
Also used for adjusting settings.
Summary of Contents for SV2
Page 1: ......
