SV Series
Spa Controls
9
Display Modes
Water Temperate / Set Temperature / Time
IMPORTANT NOTES
•
A ten (10) second idle time out period exists on non-default display modes. If the display
mode is changed the screen will time out and return to the default display after ten seconds
of idle activity has elapsed (i.e. no button presses).
•
At times the WTMP icon will not appear and the temperature reading may take a while to
update. This is normal and results from the SV control updating and performing dynamic
thermal tuning to your spa and its environment. If this occurs,
the filtration pump may
need to run for up to ten (10) minutes before the WTMP readout is refreshed.
The SV keypads feature three different display modes to select from:
Mode Icon Description
W.TMP
Water Temperature
S.TMP
Set Temperature
TIME
Clock (Time & Day)
The default display mode for all SV controller models is (W.TMP) Water
Temperature.
A short single press of the or button will navigate through the
different display modes (refer illustrations aside).
The purpose of the different display modes is to allow easy set temperature
point and clock adjustment on all SV2/SV3/SV4 models.
Please note the display mode icon at the top of the screen. These icons denote
what display mode is currently being viewed.
Other Display Icons
Filtration Cycle
The spa is performing a filtration cycle
Sanitise Cycle
The spa is performing an automatic or manual sanitisation cycle
Keypad Locked
The keypad has been locked
System Error
A fault has been detected. The system has halted operation so that
corrective action can be taken. Take note of scrolling error code and
consult trouble shooting section of this manual.
Summary of Contents for SV2
Page 1: ......
