DPU/DO - Page 7 - REV. 5/25/00
Power Pro/EC300/EC400 System Diagnostic
Overview and Requirements
The Power Pro/EC300/EC400 System Diagnostic consists of a single unit and interconnecting
cable, which connects to any Spacesaver module of mobile storage, fitted with the Power Pro,
EC300 or EC400 controls. The System Diagnostic Unit is housed in a black plastic case and
comes equipped with system communication cable, wall-mounted transformer power supply and
12 VDC auto adapter
1
. The Diagnostic Unit provides the following functions:
•
Automated troubleshooting of Power Pro, EC300 and EC400 system communication.
•
Diagnostic testing of Power Pro, EC300 and EC400 board functions such as limit switch and
safety sweep inputs.
•
Setting of system parameters on the Power Pro, EC300A and EC400 series of control boards.
•
Remote operation of a Power Pro, EC300 or EC400 module of mobile storage.
All functions are available on the System Diagnostic Unit without changing setups or operational
modes.
Requirements for Use
•
Connection to Spacesaver Power Pro, EC300 or EC400 Series Mobile Storage Controls with
provided communication cable. The Power Pro requires a ten-pin connector adapter.
•
One 120-Volt Power Supply
2
located within 5 feet of the unit. The unit will operate without
outlet power if fully charged. See page 10 for charging instructions.
1
&
2
As of October 1998, Spacesaver has changed the diagnostic unit to get its power from the
logic board eliminating the need for internal batteries, the charger unit and power jack.
