Form No. 43539049
–8–
Oct 2013
3. Secure the pilot assembly to the burner pan using two (2) #10-24 screws and nuts from the fastener kit.
See Figure 6.
4. Reattach the thermocouple to the pilot assembly by sliding it through the large hole located in the burner
pan and into the pilot assembly until it snaps into position.
5. Slide the main burner and orifice fitting through the center hole located in the burner pan. NOTE: The
tubing may need to be bent slightly by hand for alignment with the fitting. Take care not to crimp the
tubing.
6. Screw the single jet burner tube onto the orifice fitting until it is snug against the burner pan. See Figure
6. Use an adjustable wrench or pliers to hold the fitting in place while tightening the burner tube.
7. Slide the windshield into the slotted portion of the pilot holder bracket. See Figure 6.
4D. CONTROL ARM AND BURNER JET ASSEMBLY (DSI Models 5B and 5D Only)
1. Place the bracket for the gas control arm over the canopy and secure using four (4) ¼-20 screws and
nuts from the fastener kit. See Figure 6a and 6b. NOTE: Mounting the control bracket to a 34” canopy
requires use of the set of holes located at the end portion of the control bracket only. See Figure 7.
2. Attach the gas valve to the bracket and secure using four (4) #8-32 screws on control no. 5B and 5D.
FIGURE 6
FIGURE 6a
FIGURE 6
