SP Controls PixiePro PX2-MP-IR, Installation Manual

Page: 8 / 31

IV. Installation
PixiePro­may­be­mounted­using­the­plastic­surface-mounting­box­(included),­or­using­a­standard
four-gang­wall­box­(must­be­purchased­separately).­
Warning :­The­PX2-MP-IR­is­a­low-voltage­device.­Never­install­the­PixiePro­in­an­electrical­back
box­containing­high-voltage­wiring.­This­would­cause­a­serious­electrical­danger­and­violate­United
States’­electrical­codes.
1. Wall Surface Mounting
The­PixiePro­may­be­surface­mounted­to­masonry­or­drywall­with­the­included­plastic­surface­mount
box­and­anchors.­
Secure­the­surface­mount­box­to­the­wall.­Bring­the­three-conductor­cable­from­the­cable­assembly
to­the­back­box­and­feed­it­through­one­of­the­cable­channels,­located­at­the­top­and­bottom­of­the
box.­Wire­mold­may­be­used­to­guide­wiring­along­the­wall.­
To­secure­the­PixiePro­into­the­plastic­mounting­box,­line­the­circuit­board­up­with­the­box­posts­and
insert­securely­into­the­plastic­clasps.
Cover­the­PixiePro­face­with­the­included­faceplate­and­secure­with­the­included­screws.
2. Tabletop Surface Mounting
Secure­the­PixiePro­plastic­surface­mount­box­to­the­table.­Thread­the­three-conductor­cable­from
the­cable­assembly­to­the­back­box­and­feed­it­through­the­wiring­cutout.­Wire­mold­may­be­used­to
guide­wiring­along­the­table.­Alternately,­you­may­cut­an­access­hole­through­the­table­and­run
wiring­along­the­underside­of­the­table.
To­secure­the­PixiePro­into­the­surface­mount­box,­line­the­circuit­board­up­with­the­box­posts­and
insert­securely­into­the­plastic­clasps.
Cover­the­PixiePro­face­with­the­included­faceplate­and­secure­with­the­included­screws.
Plastic­Surface
Mount­Box
(included)
Release­clasps­to­remove
PixiePro­from­surface­box
5
Wall­Anchors
(included)
Wall­Anchors
PixiePro­Circuit
Board
Figure 4: Assembling­the­PixiePro­for­surface­mounting­(surface-mount­box­included)