SP Controls PixiePro PX2-MP-IR, Installation Manual

Page: 22 / 31

VIII. Configuration
Overview
Configuration­Mode­is­used­to­change­the­various­settings­on­the­PixiePro­that­control­its­behavior.
To­put­the­PixiePro­into­Configuration­Mode,­press­and­hold­any­button­while­inserting­the­paperclip
into­the­programming­aperture.­The­PixiePro­Learning­Mode­Indicator­LED­will­flash­and­the­unit­will
emit­a­regular­clicking­sound­to­indicate­it­has­entered­Configuration­Mode.­
Once­in­Configuration­Mode,­use­the­PixiePro­interface­to­navigate­through­the­configuration­set-
tings.­The­Aux­buttons­are­used­to­set­the­configuration­group.­Source­buttons­1-8­are­used­to
select­the­setting­you­wish­to­adjust­within­the­current­group.­Volume­buttons­are­used­to­select­the
desired­value­for­a­given­setting,­with­the­volume­display­providing­feedback.­Power­buttons­are
used­to­confirm­selections.
The­Volume­Control/Display­module,­all­four­Aux­button­modules,­and­at­least­seven­Source­buttons
are­
required to­fully­configure­the­PixiePro.­Be­sure­to­include­these­modules­until­the­unit­is­config-
ured.­After­configuration,­they­may­be­replaced­with­blanks.­You­may­clone­settings­from­an
already-configured­unit­without­including­these­modules.­
In­an­emergency­where­the­button­modules­are­unavailable,­you­may­simulate­button­presses­by
removing­the­blanks­and­carefully­probing­the­button­key­with­screwdriver­or­thin­metal­object.­­
Power­buttons­are
used­as­an
Enter key
in­configuration­mode
Use­Source­1-8­
to­select
Setting
Aux­Buttons­1-4
select­
Configuration
Group
Volume­Control­and
Display­used­to­set
Levels
If­the­button­modules­are­unavail-
able,­gently­touch­these­contact
points­with­a­fine­metal­implement
to­simulate­a­button­press.­
19
Figure 15: Configuring­the­PixiePro
Figure 16: Simulating­a­button­press­when­button­module­is­unavailable