14
Operation cont.
Battery Replacement
1. Lift up the tilt stand.
2. Loosen the Phillips
screws on the battery/
fuse cover.
3. Remove the battery/fuse
cover.
4. Replace the batteries with
three AAA batteries.
5. Observe proper polarity
as shown inside battery
compartment.
6. Install the battery cover and
tighten the screws.
When replacing the battery or fuses, be sure to secure
the battery compartment door firmly to maintain the waterproof and dust
proof integrity of the meter. Loose or overtightened screws, or an improperly
seated o-ring may compromise the meter's water and dust ingress protection.
WARNING:
To avoid electric shock, do not operate the meter
until the battery/fuse cover is securely fastened to the meter.
WARNING:
To avoid electric shock, remove the test leads from
the meter before removing the battery/fuse cover.
WARNINGS:
MAX
MIN
n m VA F M k
AUTO HOLD MAX MIN REL LOZ
0
10
20
30
40
13
Temperature Measurements
1. Set the rotary function switch
to the
°F °C
position.
2. Press the
MODE
button to select
readings in °F or °C.
3. Connect the Temperature Probe to
the Banana Plug Adapter. Note the
– and + markings on the adapter.
Connect the adapter to the meter,
making sure the – side goes into
the
COM
input jack and the + side goes into the
°F °C
input jack.
4. Touch the tip of the Temperature Probe to the object being
measured. Keep the probe touching the object until the
reading stabilizes (about 30 sec).
5. Read the temperature on the LCD display.
WARNING:
Do not touch the temperature probe to live circuits.
Operation cont.
MAX
MIN
n m VA F M k
AUTO HOLD MAX MIN REL LOZ
0
10
20
30
40