![background image](http://html1.mh-extra.com/html/southern-states/cbl-t/cbl-t_installation-instructions-manual_1337417011.webp)
Page 7 of 26
Summary & Introduction
Introduction
Southern States Type CBL-T switch is a center side break, low profile “V” configuration disconnect
switch for pole or structure mounting. It has two rotating insulators placed 60° apart and can be
mounted upright, inverted, or at any desired angle. The current carrying parts are copper and
copper allow with silver-to-copper transfer points. Standard mounting dimensions are 9¾ “ x 9¾”.
The CBL-T is designed for simplicity, ruggedness, reliability and attractive appearances. Using
only two insulators per phase results in cost and weight savings. All switches, including 69kV,
are normally shipped factory assembled with insulators, and fully adjusted.
The CBL-T switch may be operated with either a manual operator (swing handle or worm gear)
or a Southern States Type VM-1 Motor Operator
The instructions contained within this manual are necessary for the safe installation, maintenance,
and operation of the Type CBL-T switch. A qualified person, familiar with this of type equipment,
should carefully read and follow the instructions.
These instructions are intended to provide a general guideline for the installation, adjustment, and
maintenance of the Type CBL-T switch. All details, equipment variations, and potential conditions
may not be covered in this manual. Contact Southern States, LLC in the event conditions
associated with a specific application are not sufficiently addressed.
All photographs and sketches in this manual are for illustration purposes only and may not be to
scale. Refer to the Unit Assembly drawing or the Operating Mechanism drawing provided with
each disconnect switch for specific details. During installation, it may be necessary to make
adjustments other than those described in this manual. Contact your local representative or the
factory if questions should arise.
Southern States After Sales and Service Department is available for field installation assistance
along with providing parts support for all Southern States products.
Contact After Sales and Service at 770-946-4562, 7:30am-4:00pm EST Monday-Friday.
After Hours: 770-946-4565
Distinctive signal words are used to indicate the degree of hazard that may be encountered by
the user. Identification of the signal words and their definition follow:
Indicates a potentially hazardous situation, which, if not avoided, could result
in death or serious injury.
Indicates an imminently hazardous situation, which, if not avoided, will result in
death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, may result in
minor or moderate injury. It may also be used to alert against unsafe practices.
Summary of Contents for CBL-T
