Page 14 of 26
Installation & Adjustment Procedures
Figure 4: Blades Shown Fully Open
7. Adjustment of contact pressure – Rotate the blade assemblies into the closed
position. The pressure adjusting bolt should be left loose so as not to apply any
pressure during this first closing position. Tighten the adjusting bolt until the
contact surfaces touch. Then tighten 1/8 turn. Refer to
Error! Reference
source not found.
.
Figure 5: Contacts Shown Fully Closed
Summary of Contents for CBL-T
