Figure 33. Outfeed table positive stop bolts.
Straightedge
Outfeed Table
Figure 34. Adjusting outfeed table even with
cutterhead body.
!
Black Lines Represent
Straightedge Positions
From Overhead View
Figure 35. Straightedge positions for verifying if
outfeed table is parallel with cutterhead.
-36-
For Machines Mfd. Since 10/20
South Bend Tools
Model SB1091
S E R V I C E
5.
Place straightedge on outfeed table so it
hangs over cutterhead, then lower outfeed
table until straightedge just touches
cutterhead body, as shown in Figure 34
(rotate cutterhead if necessary).
6.
Place straightedge in positions shown in
Figure 35. In each position, straightedge
should touch cutterhead body and sit flat on
outfeed table.
— If straightedge touches cutterhead and
sits flat across outfeed table in each
position, then outfeed table is already
parallel with cutterhead. Check infeed
table to make sure that it is parallel with
outfeed table.
— If straightedge does not touch cutterhead
and sit flat on outfeed table in any
positions, then outfeed table is not
parallel with cutterhead. Correct outfeed
table parallelism, then correct infeed table
parallelism.
Checking/Adjusting
Table Parallelism
If the tables are not parallel with the cutterhead
or each other, then poor cutting results and
kickback can occur.
Tools Needed:
Qty
Straightedge ..........................................................1
Wrench or Socket 12mm ......................................1
Wrench or Socket 32mm .......................................1
Adjustable Wrench 10" .........................................1
Hex Wrench 4mm .................................................1
Duct Tape ..............................................................1
Electrical Parts Cleaner .......................................1
Checking Outfeed Table
1.
DISCONNECT MACHINE FROM POWER!
2.
Put on leather gloves.
3.
Remove cutterhead guard and fence.
4.
Loosen outfeed table lock located at front of
machine, then loosen jam nuts and positive
stop bolts located under outfeed table (see
Figure 33).
Jam Nut
Stop Bolts
Jam Nut
