DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine may
result in malfunction or unexpected results
that can lead to serious injury, death, or
machine/property damage.
Serious injury or death can result from using
this machine BEFORE understanding its
controls and related safety information. DO
NOT operate, or allow others to operate,
machine until the information is understood.
Figure 16. Digital readout battery compartment.
-20-
For Machines Mfd. Since 10/20
South Bend Tools
Model SB1091
P R E P A R A T I O N
Digital Readout
Batteries
You must install two AAA batteries in the
battery compartment for the digital readout
(DRO) to function.
To install AAA batteries in digital readout:
1.
Remove cover on battery compartment (see
Figure 16).
2.
Insert included AAA batteries, then re-
install cover.
Test Run
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, do not operate it further
until you have resolved the problem.
Note:
Refer to Troubleshooting on Page 34 for
solutions to common problems that occur with all
jointers. If you need additional help, contact our
Tech Support at (360) 734-1540.
The test run consists of verifying the following:
• Motor powers up and runs correctly.
• Emergency Stop and Knee Stop buttons work
correctly.
To test run your machine:
1.
Clear
away all tools and objects used during
assembly and preparation.
2.
Connect machine to power source. POWER
light should illuminate,
— If light does not illuminate, check power
connection.
Battery Compartment
