-40-
For Machines Mfd. Since 11/21
South Bend Tools
Model SB1125
S E R V I C E
Replacing
Worklight Bulb
The worklight bulb on this machine is a 85–265V
7W two-pronged LED bulb.
Items Needed
Qty
Phillips Head Screwdriver #2 ...............................1
Replacement Bulb (#PSB1125018) ......................1
To replace worklight bulb:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove (3) Phillips head screws shown in
Figure 68 to remove worklight assembly
from headstock.
Figure
Figure 68. Location of worklight assembly screws.
. Location of worklight assembly screws.
3.
Remove burnt bulb from socket and replace
with new one (see Figure 69).
Figure
Figure 69. Location of bulb and socket.
. Location of bulb and socket.
4.
Push worklight assembly back into
headstock and secure with Phillips head
screws removed in Step 2.
x 3
Worklight
Worklight
Assembly
Assembly
Bulb
Bulb
Socket
Socket
!
6.
Use straightedge to adjust motor pulley on
shaft until it aligns with center pulley, then
tighten set screws.
7.
Refer to Steps 4–7 of Setting Spindle
Speed on Page 25 to install drive belt for
desired speed range.