-16-
For Machines Mfd. Since 11/21
South Bend Tools
Model SB1125
P R E P A R A T I O N
Placing & Anchoring
Machine
Use a forklift to lift the machine off the pallet
and onto a suitable location, then secure the
machine to the shop floor.
This machine and its
parts are heavy! Serious
personal injury may occur
if safe moving methods are
not used. To reduce the
risk of a lifting or dropping
injury, ask others for help
and use power equipment.
To place machine:
1.
Place shipping crate near final machine
mounting location.
2.
Remove top and sides of crate from shipping
pallet.
3.
Unbolt machine from pallet by removing
(4) hex nuts and fender washers shown in
Figure 11, and remove shipping support
braces.
Figure 11. Location of hex nuts and flat washers.
Figure 11. Location of hex nuts and flat washers.
x 4
Placing Machine
4.
Install table height
crank assembly on table
height worm shaft, then tighten set screw to
secure (see Figure 12).
5.
To help balance table when moving, loosen
table height lock handle shown in Figure
12, then use table height crank to lower
table as close to base as possible.
Figure
Figure 12. Table height crank assembly installed on
. Table height crank assembly installed on
table height worm shaft.
table height worm shaft.
Table Height
Table Height
Crank
Crank
Assembly
Assembly
Table Height
Table Height
Lock
Lock
6.
Tighten table height lock handle.
7.
Place lifting sling around headstock (see
Figure 13), and attach sling securely to
forklift (or other power lifting equipment).
Figure 13. Lifting sling properly placed around
Figure 13. Lifting sling properly placed around
headstock.
headstock.