Channel Output
9
The channel signal may be assigned directly to the main L/R mix, or may be
switched to either the A or B side of the Crossfader which enables smooth transitions
between selected sources. The routing switches are interlocking.
10
The output signal level from the channel is set by the long-travel FADER.
11
The
large
illuminated
CUE switch enables the stereo pre-fade channel signal
to be routed to the DJ’s headphones and the booth monitors if required.
Jumper Options
J1,2A
Fit to enable RIAA equalisation on Line 1 (Default).
J1,2B
Fit to enable -10dBV (Non-RIAA) input level on Line 1.
J3,4
Fit in position A for Aux source pre-fade (Default).
Fit in position B for Aux source post-fade
Rear Connector Panel
Stereo Input Module
4.7
Summary of Contents for D-MIX 1000
