Page 5
CT12F
960.064 Rev # 0
TBS12S
24"
fig. 1
CT12F/FT
INSTALLATION
AID
PBB1.2S
CAUTION: SOUND ADVANCE loudspeakers utilize a
flat polystyrene material as the sound radiating
surface. Although it is resistant to mechanical
damage and is unaffected by environmental ex-
tremes, care should be observed during handling,
to avoid punctures or other damage.
SHEET ROCK CEILING AND WALL
INSTALLATION
NEW CONSTRUCTION
These instructions apply if you will be installing a
CT12F/FT with a FMB-FS Bezel or a CT12FH/FHT with
a FMB-F Bezel on sheet rock ceilings or walls, prior to
the closing of the ceiling/wall.
IF A PBB1.2S BACKBOX IS NOT REQUIRED (
VERIFY THAT LOCAL CODES DO NOT REQUIRE A
BACKBOX):
1.
Locate and identify future speaker placement.
2.
Locate the TBS12S Support Bridge.
3.
If studs/joists are 24" between centers, secure the
TBS12S Support Bridge to the front face of the
studs/joists using nails or screws. (please see fig.
1). If studs/joists are 16" between centers, identify
bending notches on the support bridge legs. Cut
and bend the legs of the support bridge 90
o
inward
at the notches and fasten the support bridge legs
to the inside face of the studs/joists with nails or
screws. The straight portion of the legs must be
aligned with the front face of the joists. (please
see fig. 2)
4.
If not previously done, run the speaker wire into
the area and secure to the stud/joist.
5.
Proceed to the “Installing the Loudspeaker” section
on these installation instructions for the selected
loudspeaker and bezel combination.
