3
XTL-W7000
JIG ON REPAIRING
When repairing this set, etc., connect the extension cable as the figure shown below.
SECTION 1
SERVICING NOTE
SLIDER board
(CN2)
SLIDER board
(CN1)
MONITOR board
(CN101)
extension cable (32P) (J-2502-093-1)
(MONITOR board (CN101)-SLIDER board (CN2))
MAIN board
(CN1851)
extension cable (50P) (J-2502-092-1)
(MAIN board (CN1851)-SLIDER board (CN1))
HOW TO PULL OUT MONITOR BLOCK IN CASE ELECTRICITY DOES NOT CIRCULATE
When monitor block does not open by fault, pull out monitor block in the following procedures.
7
gear(1 S)
6
stopper washer
(2.6
×
4.5)
1
two screws
(M2)
5
bracket (slider)
3
Rotate the worm gear in the direction of arrow
B
.
for pulling the monitor block.
8
Pull the monitor block.
Note: Don't touch except the gray portion of worm gear.
A
B
2
Open the bracket (slider)
in the direction of arrow
A
.
4
