20
XTL-W7000
3-3. MECHA Mode
1. In the ENGINEER menu screen, press the
[3]
button on the
remote commander to enter the MECHA mode and display as
following figure (MECHA mode menu).
2. To select the item in MECHA mode menu, press the
corresponding number button to menu item number.
3-3-1. AGING ROOP mode
In the MECHA mode menu screen, press the
[1]
button on the remote
commander to start the AGING ROOP mode.
Aging flow:
Operation:
[BACK]
button : Stop aging.
Back to the menu screen, when this button is
pressed during the aging stop.
[ENTER]
button : Restart aging.
Display:
CYCLE : Aging number (00000 to 99999)
TEMP
: Temperature of motor section (00h to FFh)
ERROR : Error code. It is displayed when error occurred. (Refer
to the “3-3-4. ERROR CHECK” for error code)
3-3-2. TILT AGING mode
In the MECHA mode menu screen, press the
[2]
button on the remote
commander to start the TILT AGING mode.
Aging flow:
Operation:
[BACK]
button : Stop aging.
Back to the menu screen, when this button is
pressed during the aging stop.
[ENTER]
button : Restart aging.
Display:
CYCLE : Aging number (00000 to 99999)
TEMP
: Temperature of motor section (00h to FFh)
ERROR : Error code. It is displayed when error occurred. (Refer
to the “3-3-3. ERROR CHECK” for error code)
3-3-3. FACTORY AGING mode
Not used in servicing.
3-3-4. ERROR CODE display
In the MECHA mode menu screen, press the
[4]
button on the remote
commander to display ERROR CODE as following figure.
In this mode, It displays error cord or temperature until 20 counts
when error occurred. (No.1 is latest error)
These error history are not erased, if press the
[RESET]
button.
TEST MECHA
1 AGING ROOP
2 TILT AGING
3 FACTORY AGING
4 ERROR CHECK
5 ERROR INIT
Start
Open (slide)
Close (slide)
Angle=110
°
Angle=0
°
TEST MECHA
AGING ROOP
CYCLE *****
TEMP ##
ERROR $$
Start
Angle=110
°
Angle=20
°
TEST MECHA
TILT AGING
CYCLE *****
TEMP ##
ERROR $$
TEST MECHA
ERROR CODE
01:**02:**03:**04:**05:**
06:**07:**08:**09:**10:**
11:**12:**13:**14:**15:**
16:**17:**18:**19:**20:**
