10
XTL-W7000
21
Antenna contacts
Spare contact
Ground contact
Vehicle ACC power supply
Front pillar
Front pillar
TV
2
Connect the grounding cable from the TV antenna
amplifier unit to a metal part of the car body where it can
make a good ground contact.
3
Connect the antenna input cables to the TV antenna
amplifier unit according to the markings on the amplifier
(1, 2, 3, 4, TV).
7
Connect the TV main unit and the car’s ACC power
supply.
1
Connect the antenna terminal (L-type) on the TV antenna
amplifier unit
qd
to the TV main unit.
2
Connect the accessory power supply terminal to the car’s
ACC power supply.
• Connect the ACC power supply cord from the TV main
unit to the spare contact.
• Do not connect directly to the battery.
8
Replace the front pillar molding.
9
Fasten cords out of the way.
Film antenna
(left)
qf
Film antenna
(right)
qf
Antenna
input
cable
(right)
qg
TV antenna
amplifier unit
qd
Antenna
input
cable
(left)
qg
22
Changing the transmitted frequency on
the TV unit
You can change the transmitted frequency on the built-in RF
modulator of the TV unit. The default setting is “88.3MHz”.
1
Press MENU.
2
Press
V
or
v
to select
, then press ENTER.
3
Press
V
or
v
to select “RF FREQUENCY”, then press
ENTER.
4
Press
V
or
v
to adjust the transmitted frequency.
Adjust the frequency range from “88.3MHz” to “89.9MHz”.
5
Press ENTER.
6
Press MENU.
Changing the output level on the TV unit
You can change the output level of the TV unit according to the
input level of the FM tuner of a car audio. The default setting is
“MID”.
1
Press MENU.
2
Press
V
or
v
to select
, then press ENTER.
3
Press
V
or
v
to select “RF LEVEL”, then press ENTER.
4
Press
V
or
v
to select the output level.
You can select from “HIGH”, “MID” or “LOW”.
5
Press ENTER.
6
Press MENU.
MENU
ENTER
V/v
BACK
OFF
CH+
CH
–
SEEK
–
WIDE
DSPL
SEEK+
MUTING
ENTER
PICTURE
MENU
BACK
TV/VIDEO
1
2
3
4
5
6
7
8
9
VOL
10
11
12
23
Note
To avoid the possibility of damage, you
should not use a needle or push the
button too strongly.
4
After Installation and Connections
1
Start the car’s engine.
2
Verify that the brake lights, other lights, horn, turn
indicators, and all other electrical parts operate
normally.
3
Use a ball-point pen or similar to push the Reset
button on the unit.
When you press the Reset button, the system becomes
operative.
Reset button
