NW-WM1A/WM1Z
45
5-15-10. Auto sleep setting (Auto sleep)
It can be setting the information of time-out timer setting of until
the sleep state.
Procedure:
1. Enter the test mode.
(Refer to “2. SETTING THE TEST MODE” on page 33)
2. Press the [+]/[–] keys to select the “Others”, and press the
[
u
] or [
>
] key to enter the minor item.
3. Press the [+]/[–] keys to select the “Auto sleep”.
4. Press the [
u
] key, the setting screen is displayed.
Auto sleep
(OTR SLPT command)
Auto sleep
[Normal]
>>> set
Screen display
“Normal”
or
“Quick”
or
“Long”
5. In step 4 state, each time the [
.
]/[
>
] keys are pressed,
time-out timer setting is select. (Normal/Quick/Long)
6. Press the [
u
] key, and change to the selected of in step 5.
7. Slide the [HOLD] switch in the direction of on, to return to
minor item selection screen.
5-15-11. EU volume regulation check (EU Vol regulation)
Note:
Not used for the servicing.
5-15-12. Console ON/OFF check (Console ON/OFF)
Note:
Not used for the servicing.
5-15-13. Printk ON/OFF check (Printk ON/OFF)
Note:
Not used for the servicing.
5-15-14. MSC connection control (MSC control)
It can be switched status of the MSC connection/disconnection.
Procedure:
1. Enter the test mode.
(Refer to “2. SETTING THE TEST MODE” on page 33)
2. Press the [+]/[–] keys to select the “Others”, and press the
[
u
] or [
>
] key to enter the minor item.
3. Press the [+]/[–] keys to select the “MSC control”.
4. Press the [
u
] key, the control screen is displayed.
MSC control
(OTR MASS command)
MSC control
[disconnect]
>>> set
Screen display
“disconnect”
or
“connect”
5. In this state, each time the [
.
]/[
>
] keys are pressed, MSC
connection/disconnection is select. (connect/disconnect)
6. Press the [
u
] key, and switched the selected MSC connec-
tion/disconnection status of in step 5.
7. Slide the [HOLD] switch in the direction of on, to return to
minor item selection screen.
5-15-15. ADB control (ADB control)
Note:
Not used for the servicing.
5-15-16. Display the safety standard mark
(Safety
standard)
It can be display the safety standard screen corresponding to each
destination.
Procedure:
1. Enter the test mode.
(Refer to “2. SETTING THE TEST MODE” on page 33)
2. Press the [+]/[–] keys to select the “Others”, and press the
[
u
] or [
>
] key to enter the minor item.
3. Press the [+]/[–] keys to select the “Safety standard”.
4. Press the [
u
] key, the information screen is displayed.
Note:
If the destination setting is abnormal, “invalid dest” is display. If the
model setting is abnormal, “invalid model” is display. If the detect
other abnormalities, “other error” is display.
5. Slide the [HOLD] switch in the direction of on, to return to
minor item selection screen.
