13
Collapsing the Unit
Follow the instructions below to collapse the VID-
P110 for transportation or convenience.
1
Fold both arm lights down onto the base.
2
Rotate the camera parallel to the camera stand.
Carefully fold down the camera stand toward the
operation panel side until it locks.
Cautions
• Lay the unit down flat. Do not try to stand it on its
rear or sides. Doing so may cause the unit to fall
resulting in damage or personal injury.
• Do not try to pick up this unit by the camera stand.
This may cause the unit to malfunction, and may
cause you injury.
Camera
Camera stand
Rotate parallel to
the camera stand.
Arm lights
NOT this way
Adjusting the Parts
Adjusting the camera
When the picture is not upright, rotate the camera up
and down and move it from left to right to adjust.
Adjusting the arm lights
Adjust the angle of the arm lights depending on the
object.
If the light supporting arms loosen
If the arms will not stay upright, the screw in the base
may be loose. After turning off the POWER switch,
tighten the screw as shown below.
The arm cannot stand upright.
Opening in the base for
adjusting the light
supporting arm
Tighten the screw inside
slightly, but not excessively.
Cross-headed screwdriver
NOT this way
NOT this way
