Sony URX-P40, Operating Instructions Manual

Page: 40 / 56

40
• RF POWER (RF transmit output level) select
• +48V SUPPLY (+48 V power supply) setting
(UTX-P40 only)
• POWER LOCK (POWER button lock) function
• RUNNING TIME (accumulated running time) display
• MENU MODE (menu display mode) setting
• MUTE SETTING (audio muting setting) function
(UTX-B40/P40 only)
• POWER/MUTE (power supply / audio muting) setting
(UTX-M40 only)
• AUDIO PHASE (phase switching) setting (UTX-B40
only)
• COMPANDER (compander mode) setting
• OCUPNCY SENS (motion detection sensor mode)
setting
• BATTERY TYPE (battery type) setting
• DISPLAY MODE (display setting) function
• BRIGHTNESS (display brightness) setting
• FCT RESET (factory default setting) function
• VERSION (software version) display
The following configuration menus cannot be modified
during transmission. Set these menus in transmission
stopped mode.
• GP/CH (group/channel) select
• BAND (frequency band) select (Not available on the
Japan model, Korea model, 90U model, and E model)
• RF POWER (RF transmit output level) select
• FCT RESET (factory default setting) function
Transmission stopped mode
This mode allows settings to be modified when RF
transmission has stopped.
Use this mode to make settings without risk of
interrupting other wireless traffic when setting channels
and other settings.
With the power off, press and hold the SET button and
press the POWER button or POWER/MUTE button for at
least one second to turn the power on and to display the
transmission stopped mode menu.
The following configuration menus can only be modified
in transmission stopped mode.
• GP/CH (group/channel) select
• BAND (frequency band) select (Not available on the
Japan model, Korea model, 90U model, and E model)
• RF POWER (RF transmit output level) select
• FCT RESET (factory default setting) function
Basic menu operation
The basic menu operation is the same in simple mode,
advanced mode, and transmission stopped mode.
1
Press the + or – button to display the function to be
set.
2
Press and hold the SET button until the setting starts
flashing.
3
Press the + or – button to change the setting.
4
Press the SET button to enter the setting.
If no operation is performed for 30 seconds, the display
will turn off or will dim. Pressing any button will turn the
display on again.
For details about display settings, see “Changing the
display settings (DISPLAY MODE)” (page 43).
Setting the transmit channel
Procedure for all transmitters (UTX-B40/M40/
P40)
For details about the channel groups and channels that can
be selected, refer to the “Frequency List”.
1
Press and hold the SET button and press and hold the
POWER button or POWER/MUTE button to turn the
power on in transmission stopped mode.
2
Press the + or – button to display the GP/CH menu.
3
Press and hold the SET button for one second or
longer.
Press and hold until the channel group display starts
flashing.
4
Press the + or – button to select the desired group
name, then press the SET button.
The channel group is set, and the channel number
display starts flashing.
Note
Note
Function name
Setting