29
5
Select YES, and place the N-Marks of the transmitter
and tuner in close proximity.
Information about the channel set on the tuner is sent
to the transmitter, and then the transmit channel is set.
If you do not want to set the transmitter channel,
select NO or perform no action for ten seconds or
longer to not send the setting to the transmitter.
To scan channels automatically
With the tuner power on, press and hold the NFC SYNC
button for at least three seconds to automatically start a
clear channel scan.
Procedure for portable diversity tuner
(URX-P41D)
1
Press the MENU button to display the RX1 menu or
RX2 menu, then press the + or – button to display the
CLR CH SCAN screen.
2
Press and hold the SET button for one second or
longer.
Press and hold until the channel group and “+”
display starts flashing.
3
Press the + button.
When SCAN TYPE is set to GROUP
The tuner starts to scan for an available channel in the
selected channel group. When available channels are
found, the first channel number among the available
channels starts flashing on the display.
To display the next available channel number
Press the + button.
To cancel searching
Press the – button. When you press the – button, the
display returns to the CLR CH SCAN screen.
When SCAN TYPE is set to ALL BAND
The tuner starts to scan for an available channel
within each group, and the available channels within
those groups flash in ascending band group order.
To display the next group
Press the + button.
To cancel searching
Press the – button. When you press the – button, the
display returns to the CLR CH SCAN screen.
For details about SCAN TYPE, see “Selecting the
scan type (SCAN TYPE)” (page 35).
4
Press the SET button when the desired channel
number starts flashing.
The search for available channels finishes and the
displayed channel is set.
Once a channel is confirmed, you can send the setting
via NFC communication or infrared communication,
whichever is selected using SYNC MODE.
5
Send information about the channel set on the tuner to
the transmitter.
When SYNC MODE is set to NFC
Select YES, and place the N-Marks of the transmitter
and tuner in close proximity.
When SYNC MODE is set to IR
Select YES, and place the infrared transmission port
of this unit and the infrared receptor of the transmitter
in close proximity.
Information about the channel set on the tuner is sent
to the transmitter, and then the transmit channel is set.
If you do not want to set the transmitter channel,
perform no action for ten seconds or longer. The
settings are not sent to the transmitter.
For details about NFC communication or infrared
communication, see “Configuring transmitter
settings via NFC communication or infrared
communication (SYNC RX1(2)->TX)” (page 36).
To scan channels automatically
With the tuner power on, press and hold the NFC SYNC
button for at least three seconds to automatically start a
clear channel scan.
The configuration using the NFC SYNC button starts
scanning for channels simultaneously on both tuners if
both RX1 and RX2 are turned on. If you do not want to
change channel on one of the tuners, turn the
corresponding tuner off and then scan, or start a scan
using CLR CH SCAN in the RX1 or RX2 menu.
Searching for active channels
within a group (Active Channel
Scan)
Procedure for portable diversity tuner (URX-P40)
You can search for channels in use within the specified
channel group. This is useful when using more than one
tuner in combination with a single transmitter.
Before performing this procedure, select the channel
group.
For details, see “Setting the receive channel” (page 27).
1
Press the + or – button to display the ACT CH SCAN
menu.
Note
Summary of Contents for URX-P40
Page 56: ...Sony Corporation ...
