Sony UP-960, Service Manual

Page: 16 / 94

1-10
UP-960(UC) UP-960CE(CE)
46
On the safety
• Check the operating voltage before operation.
Operate the unit only with a power source specified in the “Specifications”.
• Stop operation immediately if any liquid or solid objects fall into the cabinet.
Unplug the unit and have it checked by qualified personnel.
• Unplug the unit from a wall outlet if you will not be using it for a long time.
Disconnect the power cord by grasping the plug. Never pull the cord itself.
• Do not disassemble the cabinet. Refer servicing to qualified personnel only.
• Do not touch the cutting blade of the printer.
• Keep fingers clear of paper lid assembly and paper cutting blade when paper lid
is closing.
• Connect the power plug of the printer to a wall outlet that is safely grounded.
On operation
Do not turn the power off while the printer is printing. The thermal head may be
damaged.
On printer carriage
Do not carry and move the printer when a paper roll is being placed in the printer.
Doing so may cause malfunction.
On installation
• Place the printer on a level and stable surface during operation.
• Do not install the printer near heat sources. Avoid locations near radiators or air
ducts. Also do not subject to direct sunlight or excessive dust, humidity,
mechanical shock or vibration.
• Provide adequate air circulation to prevent heat buildup. Do not place the printer
on surfaces such as rugs, blankets, etc., or near materials such as curtains and
draperies.
• If the printer is subjected to wide and sudden changes in temperature, such as
when it is moved from a cold room to a warm room or when it is left in a room
with a heater that tends to produce large amounts of moisture, condensation may
form inside the printer. In such cases the printer will probably not work properly,
and may even develop a fault if you persist in using it. If moisture condensation
forms, turn off the power and allow the printer to stand for at least one hour.
Others
Precautions
Others
47
Maintenance
Cleaning the cabinet
Do not use strong solvents to clean the printer. Thinner or abrasive cleansers will
damage the cabinet.
Cleaning the thermal head
If the printout is dirty or white stripes appear on the printouts, clean the thermal
head using the supplied cleaning sheet.
1
Press the power ON/OFF switch to turn on the printer.
2
Press the OPEN/CLOSE button to open the door panel.
Remove the paper roll if loaded in the printer.
Others
Continue to next page m