following steps:
If an error code appears
Check the error and perform Auto Calibration again.
Select [Retry].
1
Follow the instructions on the TV screen and then press
to select [Start].
The measurement starts in a few seconds.
The measurement process takes approximately 30 seconds. A test tone is output from
each speaker in sequence.
When the measurement ends, a beep sounds and the screen switches.
2
Select the item you want.
Save:
Saves the measurement results and exits the setting process.
Retry:
Performs the Auto Calibration again.
Discard:
Exits the setting process without saving the measurement results.
3
Save the measurement results.
Select [Save] in step 3.
4
If the Speaker Relocation/Phantom Surround Back screen appears, select the
setting you want by referring to “Calibrating speaker positioning (Speaker
Relocation/Phantom Surround Back).”
Skip to step 6 if the screen does not appear in the following cases:
The set speaker pattern does not include surround back speakers but does include
surround speakers, and [Surround Speaker Position] is set to [Front].
[In-Ceiling Speaker Mode] is set to [Front & Center] or [Front].
5
6
When [Do you want to activate Calibration Matching?] appears on the screen, select
[Yes] or [No].
Yes: Expands the sweet spot for the viewing position and allows you to enjoy more
natural sound by trimming the wavefront for each pair of left/right speakers.
No: The measurement results of the Auto Calibration function are applied directly.
7
Select [Finish].
8
