Note
This setting is not available when headphones are connected.
When you press SPEAKERS on the receiver, the [Bluetooth Mode] changes to [Receiver]
automatically.
[151] Adjusting Settings
Performing Auto Calibration
5. Performing Auto Calibration
You can perform automatic calibration from your listening position.
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Auto Calibration].
2
When you use height/overheard speakers, select [Change Surround Back Speaker
Assign], and then select [Height Speakers] on the next screen.
3
Select [Proceed to configure the speaker pattern], and then set the speaker pattern
on the next screen.
If you have set [Height/Overhead Speakers] to a value other than [FH] or [---], set [Ceiling
Height] on the next screen.
4
Make sure that the calibration microphone is connected to the receiver, and then
select [Proceed to the next step].
5
Confirm the instructions on the screen, then press
to select [Start].
The measurement starts in 5 seconds.
The measurement process takes approximately 30 seconds. A test tone is output from
each speaker in sequence.
When the measurement ends, a beep sounds and the screen switches.
6
Select the item you want.
Save:
Saves the measurement results and exits the setting process.
Retry:
Performs the Auto Calibration again.
Discard:
Exits the setting process without saving the measurement results.
For details on the measurement results, see “6. Checking Auto Calibration results.”
7
